Welcome to our online shop

HAND PAINTED - FAIR TRADE

CERAMIC CORD PULLS

Sizes range between 8 cm and 10 cm high and between 2 cm and 3.5 cm wide

Click on picture for full details and to order

Price £3 each

Fitting instruction for the Fair Trade ceramic cord pulls above. As they do not have a cord supplied you can use your existing cord or a new length of cord. The hole on the cord pull is much bigger at the bottom than at the top. Tie a knot or attach a bead to the cord large enough so as not to pass through the top hole but small enough to go through the bottom hole. Feed the cord up through the bottom and then attach to your cord to your existing cord pull fitting as explained below.

FITTING INSTRUCTIONS are simple as most cord switches, such as those connected to lights and showers, have a small connector near the ceiling, which is used to connect your new cord from the cord pull to your existing cord. How to make the connection is obvious when you examine the connector.

Countries outside the UK may have different types of connection and this should be checked before placing your order.

For connecting to blinds and curtains, The cord on these must have a single cord with an end. The cord must be able to thread through a hole in the cord pull of 2 mm round and will replace the cord supplied with the cord pull. The size of the hole in the cord pull is fixed and cannot be increased. Please be sure your cord pull will fit to where you want it before ordering.

To fit the new cord to the cord pull. Feed in the cord through the cord pull (burr the end if difficulty in threading the cord) Tie a double knot and feed the loose end back into the hole. Pull the cord from the top. The knot should then disappear into the bottom of the cord pull and remain secure.

Roy and Carita thank you for using our online shop