|
FITTING INSTRUCTIONS are simple as most cord switches, such as those connected to lights and showers, have a small connector near the ceiling, which is used to connect your new cord from the cord pull to your existing cord. How to make the connection is obvious when you examine the connector.
Countries outside the UK may have different types of connection and this should be checked before placing your order.
For connecting to blinds and curtains, The cord on these must have a single cord with an end. The cord must be able to thread through a hole in the cord pull of 2 mm round and will replace the cord supplied with the cord pull. The size of the hole in the cord pull is fixed and cannot be increased. Please be sure your cord pull will fit to where you want it before ordering.
To fit the new cord to the cord pull. Feed in the cord through the cord pull (burr the end if difficulty in threading the cord) Tie a double knot and feed the loose end back into the hole. Pull the cord from the top. The knot should then disappear into the bottom of the cord pull and remain secure.
|
